These are multi channel receivers and the
IR camera will be either channel 1, 2, 3, or 4. If you order more than
one camera package, we will send different channels. If you order 4 camera kits
you get 4 camera kits with 4 different camera frequencies and 4 receivers. The
receivers have a 4 position switch on them (one for each channel). You can use
one receiver and view all 4 cameras by switching between channels on the
receiver, or you can use all 4 receivers and have each one tuned to a different
channel and watch all 4 cameras at the same time (provided you have 4 TVs or LCDs or you
can use a digital quad
processor). This system can be used with the 1.2Ghz
cameras if you require an additional 4 cameras that will not
interfere with one another, yielding 8 channels!
- Color CMOS Wireless Camera with built in Transmitter and audio
- 2.4GHz High Frequency Signal
- Receiver has Frequency Lock for 4 Channels (no fine tuning required!)
- Field of view is 24" at ~36" distance. Sharp focus from ~12" to infinity
(focus is still acceptable up to ~4")
- Two Power Transformers and one 9V battery clip
This system includes a Color Camera with Built-in Tiny High Frequency
Wireless Transmitter with receiver. The system operates on a 2.4GHz high
frequency signal. 2.4Ghz makes a huge difference in the range and quality of
video image received, especially when going through ceilings, floors and most
walls. In an unobstructed site with no other electrical interference you can
expect to clearly transmit up to 300 feet.
The video and audio is transmitted at 2.4GHz. It is NOT sent via regular UHF
TV band (Like Ch59) transmission to a channel on your TV. These cameras are NTSC
Versions (United States Standards). Installation is simple and will take less
than 3 minutes to set up. No wire to run through the house. No special knowledge
is required. Anyone can do it with an ordinary television which has a RCA input.
If needed, the video can be recorded with an ordinary VCR. The RCA output can
also plug into your PC if you have a TV card or a USB video capture feature. We
also sell LCD monitors that work great with this system.
This miniature camera has a built-in
microphone and 2.4Ghz Video & Audio transmitter. This IR camera measures
about 1.72" around and 2.2" deep. The antenna is about 1.25" long. The base is
about 1.5" from the base to the pivot point along the center line as shown in
the figure. The highly sensitive microphone can listen in a room over 300
square ft. The equipment is perfect for body worn covert applications. This
miniature camera can send video & audio powered by a 9-volt alkaline battery
(Duracell/Energizer) or the supplied AC-DC Adaptor. The camera can also be
powered by one of our 7.2V NiMH battery packs. The power RCA type of plug on the
cameras should not be cut off! You should splice the 9V battery plug to your
alternate battery to connect to the camera. It is important not to over volt the
camera/transmitter for proper performance. We found it works great on anything
above 7VDC, but should be less than 10VDC.
